Rusty's Rear Extended Sway Bar Links (JK) Lift Height:3"-4.5" Lift High Impact Polyurethane

High Impact Polyurethane

The mounts have 9/16" bolt holes and feature an inside spacing of 2-5/8"

The bracket is a simple installation and the factory license plate light transfers right to the new steel light mount as well

5" Forged Flex Joint on Frame Side and 2" Forged Flex Joint on Axle Side

We also upgrade the mounting bolt to 1/2" over the factory 10 mm hole on many Jeep vehicles

Rusty's Rear Extended Sway Bar Links (JK) Lift Height:3"-4.5" Lift High Impact PolyurethaneLifting your Jeep Wrangler increases ground clearance, but it also pulls your factory sway bar out downward of alignment if the factory links are too short for a lifted suspension. If the sway bar operates at an improper angle, this can lead to poor handling, binding, and in extreme cases, can cause the sway bar to "flip" or invert, resulting in expensive damage. Rusty's Rear Extended Sway Bar Links are engineered to correct this extending the link